Puri-T 242


1/2″ – 2″ Lead Free, solder ends

All surfaces of this product in contact with drinking water contain less than 0.25% of lead in compliance with U.S. law

Technical Data
  • Certified by CSA International to comply with U.S. s3874, California AB1953, and similar laws of other states for the safe handling of drinking water
  • 24h 100% seal test guaranteed
  • Dual sealing system allows valve to be operated in either direction making installation easier
  • No metal-to-metal moving parts
  • Handle clearly shows ball position
  • Silicone-free lubricant on all seals
  • Chrome plated lead free brass ball for longer life
  • Handle stops on body to avoid stress at stem
  • Hot forged sand blasted, unplated lead free brass body and cap sealed with Loctite® or equivalent thread sealant
  • Pure PTFE adjustable packing gland and reinforced PTFE washer for lower torque and easy maintenance
  • Blowout-proof unplated lead free brass stem
  • Pure PTFE self-lubricating seats with flexible-lip design
  • Solder-end ANSI B16.18 female by female connections

  • Full port to DIN 3357 for maximum flow
  • Geomet® carbon steel handle with thick PVC dip coating. Handle coating offers both thermal and electrical protection
  • WARNING: do not exceed reasonable temperature and/or electrical load
Working pressure & temperature
  • 600 PSI (for solder joints rating see table 1) non-shock cold working pressure
  • For general use: -4°F / +350°F (for solder joints rating see table 1)
  • NSF 61 limits (CSA approval): tested for use in continuous exposure to water of ambient temperature
  • WARNING: freezing of the fluid in the installation may severely damage the valve
  • Oval lockable handle
  • Patented locking device
  • Stem extension (assemble after soldering)
  • T-handle
  • Stubby handle
Upon request
  • Glass filled PTFE seals
  • Stainless steel handle (1.4016 / AISI 430)
  • Custom design
Approved by or in compliance with
  • GOST-R (Russia)
  • Certified by CSA International for Drinking Water to
    NSF/ANSI 61 – NSF/ANSI 372 (United States)
  • RoHS Compliant (EU)

NOTE: approvals apply to specific configuartions/sizes only.

1.1/2”- 2” hollow ball

Part descriptionQ.tyMaterial
1Unplated solder end body1CW510L
3Chrome plated ball1CW510L
4Unplated solder end-cap1CW510L
5Unplated stem packing gland design1CW510L
6Nickel plated gland nut1CW617N
7Geomet® nut1CB4FF (EN10263-2)
8Packing gland seal1PTFE
9Thrust washer1PTFE carbon filled 25%
10Green PVC coated Geomet® steel handle1DD11 (EN10111)

DN shows the nominal flow diameter. Actual flow diameter complies with full port DIN 3357 part 4.

stated limits are not imposed by the valve, but by the strength of the soldering joint according to ASME B16.22.
* This alloy contains more than 0,2% lead and, according to certain specifications, cannot be used for potable water or other foods.
** Soldered copper tube joints have been tested at 230 psi (1600 kPa) in accordance with ISO 2016

Pressure-temperature chart

              Chart applies to valve, not to solder joints for general use

Pressure drop chart
Ask for additional information on the whole range of RuB products and consult with your supplier for special applications.
XCET242 - 4266