flare 37° by solder end 1/2” – 3/4”, standard port

Technical Data
  • 24h 100% seal test guaranteed
  • Dual sealing system allows valve to be operated in either direction making installation easier
  • No metal-to-metal moving parts
  • Handle clearly shows ball position
  • Silicone-free lubricant on all seals
  • Handle stops on body to avoid stress at stem
  • Chrome plated brass ball for longer life
  • Hot forged sand blasted, unplated brass body and cap sealed with Loctite® or equivalent thread sealant
  • Finest brass according to EN 12165 and EN 12164 specifications
  • Blowout-proof nickel plated brass stem
  • Pure PTFE adjustable packing gland and reinforced washer for lower torque and easy maintenance
  • Pure PTFE self-lubricating seats with flexible-lip design
  • 1/2″ flare 37° by 1/2″ solder end
  • 3/4″ flare 37° by 3/4″ solder end

  • Standard port for compact design
  • Aluminum T-handle enameled red
  • WARNING: do not exceed reasonable temperature and/or electrical load
Working pressure & temperature
  • 600 PSI (for solder joints rating see table 1) non-shock cold working pressure
  • -4°F to +350°F  (for solder joints rating see table 1)
  • WARNING: freezing of the fluid in the installation may severely damage the valve
  • Stainless steel handle (1.4016 / AISI 430)
  • Geomet® carbon steel handle with thick PVC dip coating. Handle coating offers both thermal and electrical protection
  • Stubby handle
Upon request
  • Memory stop
Approved by or in compliance with
  • Canadian standards Association (United States, Canada)
  • GOST-R (Russia)
  • RoHS Compliant (EU)


NOTE: approvals apply to specific configurations/sizes only.

Part descriptionQ.tyMaterial
1Sand blasted unplated body1CW617N
3Chrome plated ball1CW617N
4Sand blasted unplated end-cap1CW617N
5Nickel plated stem packing gland design1CW617N
6Packing gland seal1PTFE
7Nickel plated gland nut1CW617N
8Geomet® nut1CB4FF (EN10263-2)
9Washer1PTFE carbon filled 25%
10Red T-handle1EN AC- 46100

DN shows the nominal flow diameter.

Above stated limits are not imposed by the valve, but bythe strength of the soldering joint according to ASME B16.22.
* This alloy contains more than 0,2% lead and, according to certain specifications, cannot be used for potable water or other foods.
** Soldered copper tube joints have been tested at 230 psi (1600 kPa) in accordance with ISO 2016

Pressure-temperature chart
Pressure drop chart
Ask for additional information on the whole range of RuB products and consult with your supplier for special applications.
XCE19540 - 4266