s.115 sweat end

Request Info

1/2"-2"
heavy pattern brass gate valve

Technical Data
Quality
  • Suitable for water-works, domestic and agricultural installations
  • Non rising stem suitable to most difficult applications
Body
  • Low pressure drop
  • Finely cast sand blasted heavy brass body
Stem
  • High performance PTFE stem seal
Threads
  • Solder end connections

Handle
  • Strong cast aluminum hand-wheel
  • WARNING: do not exceed reasonable temperature and/or electrical load
Working pressure & temperature
  • 200 PSI (for solder joints rating see table 1) non-shock cold working pressure
  • -4°F/+200°F (for solder joints rating see table 1)
  • WARNING: freezing of the fluid in the installation may severely damage the valve
Options
  • s.114 NPT female by female taper threads
Approved by or in compliance with
  • GOST-R (Russia)

 

NOTE: approvals apply to specific configurations/sizes only.

Part descriptionQ.tyMaterial
1Body1CW617N
2Gate1CW617N
3Stem1CW617N
4Body cap sealing1PTFE
5Cap1CW617N
6Stem ring1CW617N
7Packing gland seal1PTFE
8Packing gland1CW617N
9Packing gland nut1CW617N
10Red round handle1Steel
11Disc1Aluminum
12Handle nut1CW617N
s.115 sweat end

Above stated limits are not imposed by the valve, but by the strength of the soldering joint according to ASME B16.22.

*This alloy contains more than 0.2% lead and, according to certain specifications, cannot be used for potable water or other foods.

Ask for additional information on the whole range of RuB products and consult with your supplier for special applications.
XCE115 - 3992